Main > Main Forum

Rotary adapter for Happ/Midway 49-way Joystick

<< < (7/25) > >>

specfire:
I'm glad I'm wrong and sorry about assuming that the detection scheme was the same as the P360.

So, put me down for one of the kits.  I would definitely prefer the basic kit vice a completed package.  I can do my own soldering etc.  Just to check though that you would sell the sleeve, armature, and 12-position switch together or would you just sell the sleeve and I would have to order the parts from Happ?  Either way is OK.

Specfire

fl0yd:

--- Quote from: specfire on April 20, 2005, 04:33:15 pm ---Just to check though that you would sell the sleeve, armature, and 12-position switch together or would you just sell the sleeve and I would have to order the parts from Happ?
--- End quote ---

IntruderAlert:

--- Quote from: mahuti on April 20, 2005, 11:57:53 am ---The problem with using a trigger stick in this application, is that you can't use the 2 available trigger stick types with the rotary in its current form.

Type 1; Has dangling wires... needs to be restricted. Can't work with a rotary, unless you want a restricted movement on your rotary (bad) or you would need some elaborate sliding wiring harness

Type 2; Has a plunger that hits a plate. The rotary covers the end of the stick where the plunger would exit. Also, the combination of the rotary & the plate would make for a very deep stick.

--- End quote ---

I suppose you could use a swivel connector on the wires but the trigger type control is out because the trigger would rotate into the wrong position when you turn it

2600:

--- Quote from: fl0yd on April 20, 2005, 04:56:06 pm ---
Based on the responses, I have a meeting with the plastics company to make a protoype for the the stabilizers.  Currently the one in the picure is from my Happ Rotary.  I'm not aware of Happ selling them without the whole rotary joystick.

I hope to have some cost estimates and delivery estimates by next week.

--- End quote ---

Happ part numbers for  the sleeve(96-1012-00) and the set screws (95-8031-00).

fl0yd:

--- Quote ---Happ part numbers for
--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version