Main > Main Forum
Rotary adapter for Happ/Midway 49-way Joystick
Druin:
I can't remember how I came up with my numbering system for the pinouts on the harness, but I wasn't following any conventions. I was using the JST connector (original) but I don't know where pin 1 really is, I just took a picture of the connector and said "THis is what I'm calling pin 1" so I may be backwards. I was trying to illustrate the mapping from end to end since it's not a 1 to 1 cable and some people wanted to know how to map it.
I should go through the site info and update/correct things whenever I get a chance. I have a lot of fixing up I could do.
fl0yd:
--- Quote ---I should go through the site info and update/correct things whenever I get a chance
--- End quote ---
Have you gotten around to this?
Druin:
I think my chart was right because I found that every pin from 1 through 13 were numbered on my jst connector so that's what I followed when I made my table of pin map info and showed the picture showing where I'm calling pin 1 on the JST.
jlml:
The "everything panel" that everyone dismisses takes one step closer to reality...
--- Quote from: Lilwolf on April 20, 2005, 08:05:41 am ---Ok... just to make the ultra in way cool.
How about adding a button to the joystick?
Your already replacing the bottom 1/2 of the shaft.
--- End quote ---
fl0yd:
I agree that it would be cool to have a joystick that did it all.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version