Main > Main Forum

Special GP-Wiz49 version for DRS Mode selection via a rotary switch , etc...

<< < (3/4) > >>

Flinkly:
his version is the happs version, the midway is almost the same, but the shaft is a little smaller at the bottom...or bigger, i forget which.

RandyT:

--- Quote from: Flinkly on April 06, 2005, 03:13:17 pm ---his version is the happs version, the midway is almost the same, but the shaft is a little smaller at the bottom...or bigger, i forget which.

--- End quote ---

Smaller.


RandyT

Tiger-Heli:
Randy,

Did my question above get lost in the noise other thread traffic?

RandyT:

--- Quote from: Tiger-Heli on April 06, 2005, 03:36:06 pm ---Randy,

Did my question above get lost in the noise other thread traffic?

--- End quote ---


As this firmware won't be released until the support for software switching is in place (recent decision) there isn't a real answer for the question yet. 

Originally, I decided that shifting the buttons around would be too confusing for people to keep straight.  But it's open for debate at the moment.

RandyT

NoOne=NBA=:
Would it be feasible to reprogram the chip to use the highest 8 buttons for modeswitching?

That would eliminate the button numbering confusion between "normal" and "constant programming" modes, for the lower numbered buttons.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version