Main > Main Forum

Oldie But Goodie

<< < (4/4)

Tiger-Heli:
Actually, the proper way to use T-nuts (and the most professional way to do this also), is what OSCAR did on the Williams Multicade at http://www.oscarcontrols.com/sinistar/index.shtml  Note that the T-nuts go on the top, screws go from the bottom, dust washer is routed out, and overlay and plexi go above everything. (might have used two sheets of plexi?)

--- Quote from: Grauwulf on April 05, 2005, 11:21:24 pm ---how do you countersink bolts, or screws for that matter?

--- End quote ---
Actually, (for wood screws, not machine screws) they make countersink bits that you are supposed to use that match the chamfer of the screw head.

Navigation

[0] Message Index

[*] Previous page

Go to full version