Arcade Collecting > Miscellaneous Arcade Talk

jamma pcb voltage and current

<< < (2/2)

paigeoliver:

--- Quote from: kenzo42 on April 04, 2005, 03:23:00 am ---i need to run a load on my psu since my monitor is jacked through it. ken layton aleady gave me some advice on the resistors i should use. i was just curious on how close those load resistors would come to the pcb load.

--- End quote ---

Pcbs vary wildly, you will use the same power supply for a teeny tiny 5" square board as you will for a gigantor stack of 3 boards that are each like 16"x24".

Ken Layton:
The resistor values I specified will load the power supply to a 5 ampere load.

Navigation

[0] Message Index

[*] Previous page