Main > Main Forum
Tron restrictors???
daywane:
The Tron restrictor is at work , but you can see it is diamond shaped from the above pic.
this one is the xenophobes. much larger ID and rotated 45 degrees.
we could tell my Tron restrictor ( would some one tell me how to spell it) has seen better days. ( I did not know this, Trons were made to thin) we are adding close to .222 mill to compensate for wear.
the second pic shows what we plan to do. In large the footprint of the restrictor. no insert to go into the slot of the shaft. (more universal for other type joysticks) We only have my two to go from. No telling what others are like.
The restrictor can be no thicker than 3 mill meter thick or the ball will rub.
The diamond cut will be smaller than I have marked. It will be exact size as my tron Joystick. ( + .222 mill meters )
we plan on using clear Lexine. My stock is to thick almost 6 mill meters. I could mill it down but I still want to keep it clear so the user can just mark the screw holes and drill where needed. (Lexine is very simple to drill. It will not shatter like Plexiglas.) ( for the ones of you that have xenophobes or trons just let me know . I will predrill for you.
( well... that pic of the restrictor stinks. let me try again)
daywane:
Looking at the restrictor. I just realized... these
mahuti:
I'll buy one. No predrilled holes, please (excepting the restrictor, of course)
Xiaou2:
Well, it looks like my sticks are the tron type - but the restrictors are facing the wrong way. It I mounted them different, it should be ok but - that still leave the top part a problem.
Can someone post a tron stick pic of the top restrictor please?
Id like to see the shape and way its mounted in comparison.
Also, are there plans to repo the top restrictor as well?
coasternuts:
I happened to be de-rusting my joy right now. I have more detailed pics and I can get more accurate measurements if need be.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version