Main > Main Forum

Router bit size for T-molding.

<< < (3/4) > >>

Tekn0mega:
 Once again, BYOAC community to the rescue!  :D

  Since I am working with MDF particle, I will try a 3/32, to avoid breakage on removal.

  Ty ty ty.

 

Samstag:

--- Quote from: Lilwolf on March 16, 2005, 11:33:55 am ---I'm still hoping someone puts one up on Buy/Sell/Trade forum.
--- End quote ---

cholin:
Thats a pretty good idea except you would have to have some type of "credit rating" incase someone is gonna steal it halfway through the chain!

Tekn0mega:
 BTW: if you live in the greater Las Vegas area, Woodworkers Emporium says they have these hard to locate bits. Perhaps I helped one or two ppl with that info  ;D 

 Woodworkers Emporium- (702) 871-0722

 They close at 4 frickin 30! Who the hell closes at 4:30 in Vegas?! :P

clanggedin:
I have used a 1/16 bit on a number of projects that needed T-molding and it works. I have never had a problem with it breaking either if I have had to pull the molding back out.


Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version