Main > Main Forum

Trackball mouse-hack questions

(1/3) > >>

lustreking:
I have a couple newbie questions so forgive me if they

Lilwolf:
you can buy a prehacked one for 12 bucks from Oscar (and I highly recommend them... I have 3)... But use that number as a base.

look on ebay.  You can't find them much anywhere else.  But I bought 3 for 3 bucks each... then gave up and bought a prehacked one. 

RayB:
Umm, my (limited) understanding is you need to hack a BALL mouse, not an optical mouse. And you don't throw out the optical sensor (or do you??)


cholin:
No, you dont.  Ive seen a few reports and you can use the mouse PCB directly if you set it up right.  Some trackballs with the 6-pronged connections, you can solder the wires directly to the board.

Tahnok:

--- Quote from: cholin on March 11, 2005, 07:28:37 pm ---No, you dont.  Ive seen a few reports and you can use the mouse PCB directly if you set it up right.  Some trackballs with the 6-pronged connections, you can solder the wires directly to the board.

--- End quote ---

Yes, you can. I am using an Ultimarc trackball wired into an analog PS/2 port mouse hack. It is wired directly to the PCB without any problems.

Navigation

[0] Message Index

[#] Next page

Go to full version