Main > Main Forum

Universal Monitor/Tube mounting brackets - NO LONGER IN STOCK

<< < (10/17) > >>

1UP:

--- Quote from: Ken Layton on March 22, 2005, 10:58:03 am ---That picture shows a monitor with "universal" mounting frame installed on the bracket. What about those folks who have a monitor with standard horizontal "shelf" mounting. Shelf mount have the mounting holes spaced much diifferently than your mounting brackets. Are you selling two different brackets? Or are people with shelf mount out of luck?

If your bracket is only for mounting a universal frame monitor then your advertising should make that very clear.

--- End quote ---

I have updated the top post to clarify.

southpaw13:
BUMP---just ordered my set, money sent...

Southpaw

shmokes:
Okay....I just pulled the TV I'm going to use out of its case to measure the mounting brackets.  I'm a little concerned about the brackets on my monitor not matching up correctly with your panels.   Can you tell me if this will be compatible with your brackets?  The inside width of my cab should be okay at 26 1/2" (I'll have to add some material between the sides panels and the brackets, of course), but I'm concerned about the space between the top and bottom mount on your brackets not matching up with the top and bottom mount for my monitor.  I've attached a diagram of a front-fiew of my decased tv-monitor.  Can you tell me if this will be compatible with your brackets?

(I suppose I could have PM'd you with this, but it seemed like a good excuse for a bump  :) )

1UP:

--- Quote from: shmokes on March 27, 2005, 09:09:12 pm ---Okay....I just pulled the TV I'm going to use out of its case to measure the mounting brackets.
--- End quote ---

southpaw13:
Can I have mine as one peice.  I can always cut them if needed.  I think they would be stronger as a single unit.

Thanks,
Southpaw

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version