Main > Main Forum

playchoice power supply question

<< < (2/2)

APFelon:
Hm. Somehow I doubt that it is any different that the usual +5 -5 +12 power supplies that are such common fare nowadays... Have you located a manual and / or schematics for a Playchoice yet?

APf

Thenasty:
are we talking about a PS that has the 5v, 12v etc...or are you talking about PS for Nintendo Monitor ?
If so, you can just buy those PS for around $35.00 or so but if its a
Nintendo Monitors, it wants 100vac not 110-120vac carefull before you blow up the monitor.

Pipercub:
It has some odd-ball 24 or 36 volt output on one pin but that is only to incriment the mechanical coin counter and you could just ditch that or if you must, replace it with a 12v unit.

thebestofsteve2:
Thanks for the help guys. I did some more research. I found several schematics and manuals for the playchoice 10, however, the only ones I could find are for the dual monitor version. I need to run a single nintendo monitor. The power source model is PP-1000A (again, for dual monitor). I found the power source pinout at  http://basementarcade.com/arcade/library/manuals/p/pch1-up.pdf
take a look at page 22 on the pdf file.
Thanks, Steve

Navigation

[0] Message Index

[*] Previous page

Go to full version