Main > Main Forum
Standard drill bit size for buttons?
Wienerdog:
--- Quote from: tommy on February 24, 2005, 07:16:27 pm ---Btw ive got some 13/16 buttons
--- End quote ---
13/16... I've never seen buttons under an inch... ;)
tommy:
--- Quote from: Wienerdog on February 28, 2005, 07:51:09 pm ---
--- Quote from: tommy on February 24, 2005, 07:16:27 pm ---Btw ive got some 13/16 buttons
--- End quote ---
13/16... I've never seen buttons under an inch... ;)
--- End quote ---
they are from arlington horse racing the win , place , show buttons
Wienerdog:
--- Quote from: Knievel on February 24, 2005, 06:57:38 pm ---I know for a fact that the Wico translucent Leafs need a 1 3/16" hole.
I had to go buy another bit for the damn things.
--- End quote ---
Holy smokes, I've got the Wico translucents and just drilled holes now. I used a 1 1/8" Forstner bit. Some of the buttons were snug, and some were fine but that seemed like the right bit to use. You could get away with using a 1 3/16" bit and it might even give you better transparency, but the 1 1/8" will work.
FractalWalk:
I got WICO translucents and used a 1-1/8 spade bit.
Sephroth57:
this is what you want BTW a Hole Saw, not a huge ass drill bit
i used a 1 3/16 and it worked fine for my happs competition buttons
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version