Main > Main Forum
3 joys w/o an IPac4
rhoelsch:
My cp will be changing in order to accomodate a new trackball and spinner.
Stingray:
--- Quote from: rhoelsch on February 15, 2005, 03:34:26 pm ---...can I put the balltop and the player 1 stick on the same connections on the Ipac 2?
--- End quote ---
That's the way it's generally done. The 4way shares connections with the player 1 8way.
-S
cholin:
I dont know anything about the dedicated 4 way, but I know that, as Stingray said, that's how you do it. When you attach the wires to an iPac 2, you set both joysticks up as Player 1 Up, Down, etc. This way, whichever joystick you use will send it an UP signal basically.
rhoelsch:
Good to hear--I'm not an electronics expert by any stretch, so I'm always careful not to assume.
cholin:
One issue that's being brought up alot is the joystick right above the trackball if you plan on using it alot. Apparently, this is uncomfortable for smaller panels, so beware. I will also use DB25's when I build my panel because I know someone who works at FutureShop, and well, deals :)
Navigation
[0] Message Index
[#] Next page
Go to full version