Main > Main Forum
how to connect encoder to PC
gumby510:
I bought a mame box from mameajamma and the encoder is pre-wired. There were no instructions sent so I dont know what to do from here. There are two ps/2 ports, one labeled 'PC' and one labled 'KBD'. What do I plug in to these and where do the other ends go?
Quarters:
I'm not familiar with mameajamma but offhand I would say that PC goes to the PC keyboard ps2 port and Kbd will run to your keyboard if you want one. You appear to have payed a lot of money for your cab. May I suggest sending questions to mameajamma support?
http://www.mameajamma.com/support.html
gumby510:
Ya I had it hooked up right just the computer upon booting is saying Keyboard not found. I checked the jumpers and they are on PS2 so I'm at a lose here. I guess I will have to have them ship me a new encorder.
Sasquatch!:
That sounds a lot like a loose connector.
gumby510:
What connector? I checked the ps2 cable to make sure it was plugged in all the way. Thanks for all the replys I really wanna play this thing bad :(
Navigation
[0] Message Index
[#] Next page
Go to full version