Main > Main Forum

t-moulding

(1/2) > >>

sodapopinski:
I just found a router bit that will cut the groove for t-moulding. What size is the kerf suppose to be? the bit is about 1/8".

TalkingOctopus:
1/8" is too big.  It needs to be 1/16".  Many people, including myself ordered a bit here:

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html

stellarola:
They also sell the same bit at Lowes.

Jabba:
You can also special order a 1/16" Freud bit (the best) at Home Depot. Its Called a Freud 1/6" Slot Cutter...

FractalWalk:
Am I the only one that used 3/32". That worked perfectly for me. It holds tight but still lets me remove it without taking a pound of MDF with it.

Navigation

[0] Message Index

[#] Next page

Go to full version