Main > Main Forum
ARCADE TRACKBALL will it work with OPTI - PAC ???
BUCKETHEAD:
PS.
If i was the real BUCKETHEAD.
I probably wouldn't be here trying to get tips to build a cabinet.
I would be Loaded enough $$$$
To just to buy one.
Stingray:
--- Quote from: BUCKETHEAD on February 10, 2005, 03:48:47 pm ---
I just didn't know if the wiring harness for like a HAPP is different from that of a
old CENTIPEDE cabinet trackball
--- End quote ---
Regardless of what kind you get you're going to have to cut off the plug and wire it into the optipac, it's not going to just plug in.
--- Quote from: BUCKETHEAD on February 10, 2005, 03:48:47 pm ---Anyways thanks! >:(
--- End quote ---
You're welcome. >:(
-S
BUCKETHEAD:
THANK YOU! :)
I have seen a picture of a OPTI - PAC and also the I - PAC
and noticed you had to wire everything into them.
again .... THANK YOU!
RayB:
If you used a Centipede trackball, I would just check online to find out what voltage it runs off, and also to make sure exactly which pins are supposed to go with what wire. Other than that, most trackballs are pretty standard.
Matt Berry:
I have a centipede trackball that I tried a couple different ways of hooking up but it never worked right. The cursor would just sit there and flutter. Maybe either the boards were bad, or I never had it hooked up right, either way I couldn't get it to work so far. I have a couple of other trackballs so I didn't spend a lot of time with it either, and yes everything was spinning / aligned ect.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version