Main > Main Forum
New Product - V2 spinner & Push Kit
spiffyshoes:
I couldn't wait to play with my new Spinner so I made a temp. controll panel out of the box it came in.
NoOne=NBA=:
--- Quote from: spiffyshoes on February 18, 2005, 01:24:13 pm ---I made a temp. controll panel out of the box it came in. :)
--- End quote ---
I told you to build a modular CP.
All I did was rip a flightstick hack I don't use anymore out of ITS module, and stuff the V2 into it.
sWampy:
Finally got mine hooked up, great spinner. One small improvement might be a way to mount the encoder on the other sides where the spinner could fit in a little bit tigher spaces. Since the mounting ears already stick out 3.4 inches, and the encoder board is almost 3 inches, you could fit the spinner in a 3.4x2 inch space, rather than 3.4x3, if the encoder was just attached to the wide side.
KevSteele:
VERY, VERY Cool...
Good job!
RayB:
Oscar, I tried ordering the box that Spiffyshoes used, but it's not on your order page! how do I order it?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version