Main > Main Forum

New Product - V2 spinner & Push Kit

<< < (6/19) > >>

OSCAR:
Here are some more dimensions of the V2 w/ the Push Kit


Note that the shaft is shown set up for a 3/4" control panel.  If your control panel thickness will be less than 3/4" add the difference between your cp thickness and 3/4", and add that to the overall depth.  For example, if you have a 1/2" thick control panel, add 1/4" to the overall depth as that is the amount that the shaft and switch bracket will need to slide down.

Shape D.:

--- Quote from: GGKoul on February 08, 2005, 10:55:32 am ---Oscar,

You said above that you're working on adding a pull to this spinner.  Just wondering if one purchases the Spinner with the push now, would the pull be a simple attachment? 

Thanks!

--- End quote ---
worst case senario you'd just have to buy the pus/pull set up if it becomes available. the way I see it ill only end up out $18 at the most.

OSCAR:
Lilwolf - the V2 has very good response, very close to the Vortex.  For Tempest, I had it set up for my Vortex and had the Sensitivity set at 40%.  To get the same amount of travel with the V2, I changed the Sensitivity setting to just around 50%.  For those interested, 180 deg of knob rotation should give you 3 full "spots" in Tempest to be the same as the original game.  A customer sent me this info, and I recently verified it for myself when one of my buddies picked up a Tempest cab.  :)


GGKoul:

--- Quote from: Shape D. on February 08, 2005, 06:27:11 pm ---
--- Quote from: GGKoul on February 08, 2005, 10:55:32 am ---Oscar,

You said above that you're working on adding a pull to this spinner.
--- End quote ---

--- End quote ---

1UP:
Thanks for the dimensions!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version