Main > Main Forum
Has anyone had an issue with oversized disconnects?
shawnzilla:
I ordered my quick disconnects for 22 AWG wire from Hosfelt. Now that I'm wiring up my controls, I've discoverd that they are slightly too big and are fairly loose on the microswitches. So loose, that even moderate jolting dislodges them from the switch.
Has anyone else encountered this issue? Where could I get disconnects that have a tighter fit?
KrawDaddy:
did you buy .187 or .250?
quarterback:
I gently squeezed my .250s on either side with a pair of pliers and they fit nice and tight on the male .187 tabs.
___
squeeze here---> U U <--- and here
shawnzilla:
.187
--- Quote from: KrawDaddy on January 15, 2005, 11:01:06 pm ---did you buy .187 or .250?
--- End quote ---
Crazy Cooter:
Doesn't Peale sell them by the bundle? Otherwise you'll have to raid the local hardware stores.
Navigation
[0] Message Index
[#] Next page
Go to full version