Main > Main Forum

Golden tee

(1/2) > >>

vivagolf:
I have a Golden tee 2k that was put in a Spy Hunter cabinet.
I want to upgrade to a  2002 and put in the flyby and backspin buttons.
The jamma connector is not labeled so I do not know which wires are for those buttons. Can anyone help.
Thanks,
Larry

Ken Layton:
Contact the manufacturer www.itsgames.com for more information on the Golden Tee series.

Grauwulf:
I'm sure someone will correct me if I'm wrong, but I don't believe the board sets are the same. You can only upgrade the board you have to 2k (which has already been done). The ones newer than that use a different board.

Ken Layton:
That's why I mentioned contacting the manufacturer since their are so many versions of Golden Tee and the circuit boards it runs on. I remember that there were red colored circuit boards and green colored circuit boards. Then you also had to note whether you have black connectors or white connectors on the boards.

dabone:
Golden Tee 96 (3d) thru 2k and Golden Tee classics all run on the same hardware.

(There are different upgrade kits depending on the serial number of your board,
and if you have a single board or a 3 board set)

Anything after that is quite a different machine, has a hard drive and cdrom.

To go past Golden Tee Classic or 2k you would need a new board set, etc.

Like this.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=13716&item=6140368730&rd=1&ssPageName=WDVW

Also, they support hires monitors like the 9200.

If you look close you can see the pc video card installed on that boardset.


Later,
dabone

Navigation

[0] Message Index

[#] Next page

Go to full version