Main > Main Forum

Quick Release CP

<< < (2/4) > >>

Stingray:
I started to use a SCSI cable, but determined that I wouldn't need nearly that many inputs, so I used a printer cable instead.

-S

Minwah:
I use 12-way molex connectors - 1 for each player.  I only have a max. of 2 players tho.

Still, they can be disconnected/connected very quickly.

jck_strw:
Thanks for the tips.  If I don't go with with a SCSI/printer cable, I was thinking of going the molex-connector-for-each-player-route.

GGKoul:

--- Quote from: Stingray on December 09, 2004, 08:51:50 am ---I started to use a SCSI cable, but determined that I wouldn't need nearly that many inputs, so I used a printer cable instead.

-S

--- End quote ---

I used a printer cable, but the wires were too thin and were very difficult to wire up.  Then I tried Ethernet cables, and I ran into an issue with each wire being wired differently.... so I'm in the process of used molex connectors.


SirPoonga:
My cabinet is designed like this.

For wires I just run the wires from the joysticks and buttons to a db25 connector (then to the ipac).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version