Main > Main Forum

New Product: Versa-Ball Joystick Replacement Shafts

<< < (17/20) > >>

whammoed:

--- Quote from: RandyT on February 18, 2005, 09:13:42 pm ---But I was curious as to the plastic spacer.
--- End quote ---

quarterback:

--- Quote from: whammoed on February 18, 2005, 07:42:23 pm ---OK, heres the news on the versaball and Ms Pac base:
--- End quote ---

Is this the 1 3/8" dark red shiny Versa-Ball?

Also, it looks like there a ridge around the 'equator' of this ball top.  Is there?  Can you feel it?
Thanks

whammoed:

--- Quote from: quarterback on February 19, 2005, 02:29:40 am ---
--- Quote from: whammoed on February 18, 2005, 07:42:23 pm ---OK, heres the news on the versaball and Ms Pac base:
--- End quote ---

Is this the 1 3/8" dark red shiny Versa-Ball?

Also, it looks like there a ridge around the 'equator' of this ball top.
--- End quote ---

spidermonkey:
I've made extra grooves by putting the joystick shaft into a drill chuck just as you would a bit. I then *carefully* clamp the drill down in a vise. I then engage the trigger lock so that the drill stays running. I then make a mark where I want my groove and take a fine tooth hacksaw just hold it down on my mark and let the drill do the work for me. Keep trying the e-clip several times during the process so that you don't cut any deeper then necessary. Lastly I take a fine piece of emery cloth and buff off the burrs while its still spinning in the drill. Thats it.

JODY:
Original Ms. Pacman / Galaga reunion stick.
Old and new handle pic.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version