Main > Main Forum
New Product: Versa-Ball Joystick Replacement Shafts
RandyT:
--- Quote from: spiffyshoes on November 24, 2004, 06:55:52 pm ---Randy: The E-Clips on the Pac Man Revolution joysticks are 5cm apart and the shaft is 10mm thick. From the end of the shaft to the bottom of the ball is about 8 cm total. And the Diameter of the Ball is about 1-1/4" thick.
--- End quote ---
Excellent. Thank you for the info spiffyshoes!
But just to clarify, are you referring to the Pac-Man Reunion / Galaga joystick?
Thanks,
RandyT
spiffyshoes:
Yeah, the Pac Man reunion was the one I was talking about.
RandyT:
--- Quote from: spiffyshoes on November 25, 2004, 12:43:47 am ---Yeah, the Pac Man reunion was the one I was talking about.
--- End quote ---
Great. Thanks. :)
Based on this, I have high confidence that the Versa-Ball sticks will indeed work with the Pac Man Reunion/Galaga joysticks. Both sets of grooves appear to be at the right places, which means installation in either 1/2" or 3/4"+ thick panels should be possible and would extend the height by about 4 cm in either setting.
I'll update the main post with this info.
RandyT
pcates:
Randy do you have any that will fit a nintendo joystick? I have a stick for my Donkey Kong that was originally in a metal panel (too short). The stick is only 6mm thick. Can you help???
Patrick
RandyT:
--- Quote from: pcates on November 25, 2004, 01:28:37 am ---Randy do you have any that will fit a nintendo joystick? I have a stick for my Donkey Kong that was originally in a metal panel (too short). The stick is only 6mm thick. Can you help???
--- End quote ---
Sorry Patrick,
I'd like to help, but I don't think the demand would be very high for these. At best it would be a one-off situation and probably pretty costly to do.
You might want to consider just replacing the whole stick. Could be a better solution in the long run.
RandyT
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version