Main > Main Forum
Random coin insertions
DYNAGOD:
yea, its nothing a small application of high explosives cant resolve. ;D
DYNAGOD:
i had a link to another egret owners site ,and i swear there was a write up on the same problem on his site, but ill be damned if i can find the link or the site..
im certain even the term "random coin insertions "was used, but becuase its such a low travelled site, googling that term has yielded nothing..
ive gotta figure this out , or else im gonna have to rip the whole thing apart and supergun it on my floor..
JustMichael:
If you are using the switches with the wire for detecting the coins make sure that you have hooked up the NO tab (normally open) to the interface and the ground to the COM tab (common).
DYNAGOD:
--- Quote from: JustMichael on November 20, 2004, 06:49:19 pm ---If you are using the switches with the wire for detecting the coins make sure that you have hooked up the NO tab (normally open) to the interface and the ground to the COM tab (common).
--- End quote ---
Ive went so far as to completely remove the switches from the coin mech and electrical tape the wire ends..
It still does it...
im leaning twords demonic posession ,maybe i need a priest not a tecnician ;D
StephenH:
Try deleting the .CFG file for each game that is doing this, and reconfigure MAME for the J-PAC. Make sure that coin inputs are not improperly mapped as the same keys that are used for gameplay.
You might also try opening a word processor or text editor and press your controls, and see if each correspond to the correct key mappings, and if there is some pattern via keys pressed, to the coin insertion key (which in most cases maps 5).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version