Main > Main Forum

T-Molding is not as soft as I thought it would be

<< < (2/3) > >>

Jabba:
Here's a picture of what the guys are discussing...

http://www.garry.ca/images/Day26_TMolding-Notch3.JPG

About a 1/4 of an inch should do to get a 90 degree bend...

Snarbald:
Just a thought, are you playing with the t-moulding in a cold garage? Cuz the colder it is the less flexible plastic usually is.

shmokes:
I'm using aluminum t-molding.  Haven't played with it yet (and won't get a chance to until at least mid-December when school is out).  I have a feeling that it's going to be a pain in the butt to work with.  I'm planning to cut the stem off to get around corners with a dremel tool and a diamond saw bit.  If that doesn't work I don't know what I'll use.  

fatbasta:
I rounded all the corners of my arcade just to make the t-molding installation easier.

ras2a:
I've not actually tried this, but couldn't you bang it into a bowl of warm water for a few mins to make it more malleable?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version