Main > Main Forum

Power cord / grommet question

<< < (2/3) > >>

danny_galaga:

--- Quote from: Minwah on November 09, 2004, 06:33:14 pm ---What I did was use a mains 'chassis socket', and then a separate power lead (just a PC/PC monitor one).

You can just about see mine here:

--- End quote ---

same here. nice n tidy, and you can take the cord off when youre moving the cab around

currygoat11:
Can I pick up one of these chassis sockets at a Lowes or Home Depot?  

SteveJ34:
Similar to the connector you posted, I stole/hacked the extra AC male adaptor off the back of an old AT power supply, fashioned a mounting hole using drlll and dremel, and mounted that to back of cab.

somunny:
currygoat,

Try Grainger or McMaster-Carr for the socket.  At the moment, I can't remember which one I ordered mine from.



Coop

Minwah:

--- Quote from: SteveJ34 on November 10, 2004, 12:30:10 am ---Similar to the connector you posted, I stole/hacked the extra AC male adaptor off the back of an old AT power supply, fashioned a mounting hole using drlll and dremel, and mounted that to back of cab.

--- End quote ---

That's basically what I did...but used the socket from a new Zalman PSU which I didn't need the socket on (I added a line socket & short length of cable to it).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version