Main > Main Forum

Happ Highball Trackball Lip problem?

(1/2) > >>

ras2a:
I've seen another thread on this but it was a little vague.  I Have a Highball Trackball and have noticed that the lip sits slightly above the trackball plate.  I have flush-mounted the trackball plate in my CPanel and am worried about laying the CPO and lexan over the top.  I assume the lexan will be ever so slightly raised (in the middle) because of this lip.  Any suggestions what can be done about this?  Sanding the lip off perhaps so that the lexan sits flush firm against the CP ?

cheers

whammoed:
I believe you cut the lexan to fit around the lip so the lip is flush with the lexan...I believe this is the very reason a high lip version exists.

ras2a:
The lexan for my cp is 4mm thick...I don't think the lip on the trackball rides up this far...?

whammoed:
I would think it is 1/8" or 3.175mm.  Close enough no?

JustMichael:
If the lip on the trackball is too high, why not lower the trackball?  You could stick washers on the posts above the trackball to take up the extra space.

Navigation

[0] Message Index

[#] Next page

Go to full version