Main > Main Forum
Help: T-Molding Bit In Canada.
Demon-Seed:
Hello
I am finally going to buy a t-molding bit. I am in Canada and have no clue what to get... I checked t-molding.com and in the installation tools section they have a bit that looks correct, and they say it works.
3 Wing Slot Cutter Assembly - 1/16" Slot #38
Is this what i need for my router to install tmolding? If so where in canada can i get it.. 27$ usa is a bit (ehhe a bit get it) steep for me.. anyone advise? i need it asap!
thx
JIM
Oldskool:
http://www.1blades.com/
They're in Saskatchewan, and very reasonable.
Jabba:
I bought a Freud 1/16th slot cutting bit at Home Depot. I had to special order it and it took a week to come in, but you know what...No Duty, No Shipping Fees, etc. You will also need to buy a 1/4" shaft to hold the slot cutter if you do not have one already.
I forgot what it cost, but I know it was cheaper than ordering.
Good Luck!
Grauwulf:
You don't say where in Ontario you are, but if you're in the GTA, there is a hardware place in a strip mall at Derry and Tomken in Mississauga that is a Freud dealer. Freud's Canada office/warehouse is about two blocks away on Pacific. You pay for the bit at the hardware store and then drive over to the warehouse to pick it up. That's what I did.
menace:
Grauwulf--How much was it at the strip mall place you went to? Can you recall the name of the store?
Navigation
[0] Message Index
[#] Next page
Go to full version