Main > Main Forum
Trying to interface Interact Gas Pedals with Arcade
Trimoor:
--- Quote ---Can't you just recalibrate in windows?
--- End quote ---
If I remember properly, the Dreamcast doesn't use windows! 8)
u_rebelscum:
--- Quote from: Trimoor on October 11, 2004, 04:44:50 am ---
--- Quote ---Can't you just recalibrate in windows?
--- End quote ---
If I remember properly, the Dreamcast doesn't use windows! 8)
--- End quote ---
D'oh! I was somewhere else when I wrote that. :-[
AKAIK (and it's not that much):
a) dreamcast calibrates the center on bootup
b) IIRC, each pedal should output a range of ~2.5 volts (2.3v should be enough); I think one does ~ 0.2-2.5, the other ~ 2.5-4.8. I don't know the supplied current, but V = I * R. "The rest is left as an exerise for the student."
A couple things to note: since it's calibrated at bootup, the center volts can be other than 2.5, but the ends still need to be ~0.2v and ~4.8v. Also, I'm basing this off a couple different gamepads; the dreamcast pedals might be different (but I doubt it).
Navigation
[0] Message Index
[*] Previous page
Go to full version