Main > Main Forum
Quick connectors
Craig:
I am wondering what size do joystick and pushbutton microswitch quick connectors/quick disconnects are needed?
Is it 4.8mm/4.7mm spades?
Pieman2004:
The size of the QD's vary by the manufacturer. My joysticks needed .250" and my buttons needed .187" I don't know about in mm though.
Craig:
I thought I'd look into it before getting my parts. Now I will wait until I get the joys and buttons.
Americans use inches, mm is what Aussies use but I can convert into mm's. .187" is around 4.7mm.
Thanks. ;-)
Wizard of DelRay:
--- Quote from: Wonder Boy on September 17, 2004, 02:29:09 pm ---Americans use inches, mm is what Aussies use
--- End quote ---
Yeah, unfortunately that's true. I myself prefer to use the metric system as it is an easier, more organized system of measurement. Back to the sticks though, Happ joysticks use .187 and Ultimarc joysticks I believe, use .250.
RayB:
I've noticed some microswitch tabs are designed to accomodate two sizes. The tips are narrow, and then it tapers up to a wider width. So, if your quick connects are too wide for the narrow part, just push them further, over the wide part.
Navigation
[0] Message Index
[#] Next page
Go to full version