Main > Main Forum
Looking for the demensions of this cab (Attn: Paige)
Witchboard:
Or just replace the title with "Cabinet ID." He loves those.
barranger:
--- Quote from: spystyle on September 13, 2004, 04:55:17 pm --- Maybe you should add his name to the thread title (done by modifying the initial post) once he sees his name he'll be too curious not to look, it's very strategic!
--- End quote ---
At this point anythings worth a try to get this solved :)
Thanks a million,
Barranger
brained:
I'll post the measurements of my CP tonight, sorry been kinda busy. 8)
barranger:
--- Quote from: spystyle on September 13, 2004, 04:55:17 pm ---I think it's a Dynamo cab, I have one I can measure, see this thread about it :
http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=24392
--- End quote ---
Actually looking at it again this morning, I think there different (location of coin mech, shape of the sides) but I do believe it's the same as brained's MKII machine.
Thanks again for everyone's help,
Barranger
barranger:
Also brained,
What monitor are you putting in yours? I'm thinking about putting a 19" computer monitor but I'm thinking it may look a little small in there ( the horizontal cavity space is 25 1/2" ).
Thanks,
Barranger
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version