Main > Main Forum

Getting the joysticks OUT of an X-Arcade

<< < (2/3) > >>

stellarola:
I removed my sticks to put in my Control Panel. Just use a small flathead screwdriver to get in there to get a good grip.  ;)

Darkstalker:
You could try a pair of vise grips too.  Works much easier.

Gunstar Hero:
"When all else fails use fire."

Dekelia:

--- Quote from: stellarola on September 07, 2004, 11:07:38 pm ---I removed my sticks to put in my Control Panel. Just use a small flathead screwdriver to get in there to get a good grip.  ;)

--- End quote ---

I don't really understand what you mean.  What do you do with the flat head screwdriver?

AlanS17:
I think he means getting the screw driver up underneath the head to pull up and hold it still while you screw from the other side.

If the pliers didn't work I might have to recommend the Dremel. But BE CAREFUL! If you go that route, use the fastest speed available and use good eye protection. A low speed will cause the thing to jump and potentially damage the X-Arcade.

If possible, cut underneath between the nut and the board. Avoid working on top because you're bound to booger it up. Working underneath leaves more room for error. Plus I guess I don't need to tell you to move away any wires that are even remotely close. If the Dremel jumps and splits a wire (and I speak from experience) it can be a pain in the butt.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version