Main > Main Forum

Trackball with smallest footprint?

(1/3) > >>

Stormy151:
I am considering building a mini/bartop cabinet for my niece, and would like to have a joystick, spinner, and trackball on the CP.  I plan to base the size of the CP off the size of the trackball, since it will take up the most real estate under the panel.

What's the smallest footprint 2 1/4 trackball availiable?  Or are they all about the same?

whammoed:
I have used a happs and a wico/ultimarc and they seem to be the same footprint.  If you've got big $$$ there is a smaller option:
http://www.happcontrols.com/trackballs/56020000.htm

Bgnome:
if you want the smallest footprint available, you may not want a 2.25" ball.  I think it would be safe to assume that they have the same footprint.  I have a wico command control trackball and dont see how that could possibly get less than 5" square.
as whammoed suggested, i think you should look into a smaller trackball.  i think there was a thread where someone had some penny and giles balls that were really small..

javeryh:

--- Quote from: whammoed on September 02, 2004, 09:47:31 pm ---I have used a happs and a wico/ultimarc and they seem to be the same footprint.  If you've got big $$$ there is a smaller option:
http://www.happcontrols.com/trackballs/56020000.htm

--- End quote ---

Wow that's a lot of $$$!

SirPoonga:
For the most part tballs are standardize so most use the same footprint.

Navigation

[0] Message Index

[#] Next page

Go to full version