Main > Main Forum

CP Control Mounting Question

<< < (2/2)

Dekelia:

--- Quote from: tahnok100 on August 19, 2004, 06:31:03 pm ---... exept you might want to use the Happ high lip ball instead...

--- End quote ---

What exactly is this and how do I specify I want it when ordering (do they call it "high lip")?

I am planning on countersinking the mounting plate and putting laminate over it.  Do I need to make sure I get a special trackball?  I hadn't heard of that before.
 

u_rebelscum:

--- Quote from: Dekelia on August 20, 2004, 01:47:04 pm ---
--- Quote from: tahnok100 on August 19, 2004, 06:31:03 pm ---... exept you might want to use the Happ high lip ball instead...

--- End quote ---

What exactly is this and how do I specify I want it when ordering (do they call it "high lip")?

I am planning on countersinking the mounting plate and putting laminate over it.  Do I need to make sure I get a special trackball?  I hadn't heard of that before.

--- End quote ---

http://www.happcontrols.com/trackballs/56010011.htm

The high lip has a 1/8" taller lip than the original 1/16" (for a total of 3/16").  AKA Golden Tee TB, because the GT CPs changed from 1/16" metal to 3/16" at some version.  The same amount of ball shows above the top of the lip.

The mounting plate is 1/16" thick, so if you're going to add any thickness over your CP, it's a good idea to get the high lip version.

Navigation

[0] Message Index

[*] Previous page

Go to full version