Main > Main Forum

Will this Router Bit work?

<< < (5/7) > >>

rdagger:

--- Quote from: enchntr on August 13, 2004, 04:51:13 pm ---I used a good utility knife and notched the inside and outside corners.  Worked flawlessly.
Ed

--- End quote ---

Could you explain how the notches should be cut?

marsmarvin:

--- Quote ---Could you explain how the notches should be cut?"
--- End quote ---

Spystyle has a good explaination with pictures about 2/3rds down this page:

http://spystyle.arcadecontrols.com/index4.htm

marsmarvin:
By the way, I said last week that I'll need glue with the 3/32 inch slot, but I was wrong.  It turns out that after painting, 3/32 is not too big afterall.  

Sorry I doubted Saint.

atog:
yep basically how it's shown in that picture, just remove some of the slot in the area where it has to bend around the corner.  

RacerX:

--- Quote from: reebboy on August 12, 2004, 09:12:43 pm ---Here is the direct link to the 3 wing slot cutters on mlcs. This is the best deal in town. They don't charge for shipping in the USA either.

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html

--- End quote ---

I also ordered my slot cutter from MLCS, and I was very pleased with the speed of shipping.  I can't recommend them enough.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version