Main > Main Forum

Securing Lexan to Control Panel

<< < (2/3) > >>

rdagger:
I used screwposts.
http://www.screwpost.com/

Brad Lee:
Thats the same thing I got above. Never really imagined there would be an entire company dedicated to that single item :)

big_garryb:
maybe im alone in this - but i found that my buttoms screwed down were secure enough to hold the plexi down. to t-mold around the edge was fine too. everything is secure with no flappy bits.

garry

Chris:
In my old CP I used #8 screws with finishing washers.  On my current CP I just let the buttons do the work.

--Chris

pathdoc2:
I paint my lexan control panels from underneath with paint desinged for painting lexan remote control car bodies.   After paint dries I epoxy to control panel surface.  You could just as easily put a bolt in each corner and allow the buttons to hold the lexan in place.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version