Main > Main Forum

Router Bit Retard

<< < (2/2)

Nannuu:
No worries.  I've put new T-molding on old cabs and there were pretty loose, just run a bead of glue in there before you press it in.  If it starts to pop up run some pieces of masking tape around the edge until it dries.

BigNIck:
"Subtract 1/32" from the t-molding channel insert width." ?

Explain this image. 1/16 molding in a 3/32 slot?





JustMichael:
BigNIck, the 3/32" is from barb to barb on the t-molding.  You want the barbs on the t-molding to dig into the slot so the barbs will hold the t-molding on.  Therefore, you must make the slot smaller than the barb to barb dimension.

Navigation

[0] Message Index

[*] Previous page

Go to full version