Main > Main Forum

How can i reuse\fix\alter an existing metal CP

<< < (4/5) > >>

abrannan:
I had a new control panel made for my Reactor cabinet from a local sheet metal shop.  They used 16 ga. steel, which was much thinner than the 13 ga. steel the original was made from, but it's plenty thick for my purposes.  Cost me $20, but I had to punch the holes myself.

Hoagie_one:
HOW DID YOU PUNCH THE HOLES IN IT?

SirPeale:
I'd use a Greenlee hole punch.  Pricey, but worth it.

Hoagie_one:
how would you use one of those without a press?

ChadTower:

--- Quote from: Hoagie_one on July 07, 2004, 09:41:04 am ---HOW DID YOU PUNCH THE HOLES IN IT?

--- End quote ---

Ron Jeremy.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version