Main > Main Forum
arkanoid spinner pinout needed
Aceldamor:
--- Quote from: jerryjanis on July 03, 2004, 09:41:07 pm ---Here's a thread with a couple of picturs of some other optic boards. I have been able to figure out some optic boards from similar pictures by tracing the circuitboard and seeing which ones go to the resistor:
http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=9837;start=msg73421#msg73421
--- End quote ---
heh...glad to know i've contributed at least a little to this hobby that benefits everyone else ;D
Kremmit:
I got an Arkanoid spinner recently in a box of parts. It looks good, but it buzzes like mad. I don't remember it doing that when I played it at the pizza place unless you spun it really hard (like when you were heading for that warp/exit thing on the side).
Is my memory messed up, or is something out of whack with this spinner? Were the gears lubricated or anything?
RayB:
I have one too. It does pretty much the same thing.
You have to remember that when installed in a solid commercial quality cabinet, the control panel dampened much of the noise.
On the other hand, it could certainly use a cleaning + re-lube.
Kremmit:
Mine's already really clean- like mabye it was never even used. But there's no sign of ANY lube on it... that's what I was wondering about. Where did you lube yours, on the gears, the shafts, or both? What did you lube with?
Thanx!
Navigation
[0] Message Index
[*] Previous page
Go to full version