Main > Main Forum
How long is your stick? :o
danny_galaga:
--- Quote from: etumor on June 08, 2004, 11:50:46 am ---
--- Quote from: danny_galaga on June 08, 2004, 12:50:48 am ---
--- End quote ---
A quick off-topic question Danny,
What did you use to drill through the aluminum? Was it just a standard hole saw or did you use a forstner bit? I checked your website, but you don't say specifically.
-Jeff "etumor" Allen
--- End quote ---
I used a good quality hole saw, which sort of made up for my bad quality hole sawing! Doing that meant I could put the ali in place and saw through both ali and MDF at once. The holes are a bit rough on the ali but cant be seen when switches are in. joystick hole was with drill bits. Drill small hole first and then progress two or three sizes to final size
crashwg:
Well, my GF doesn't seem to have any problems with the height of the stick, so... I guess I'll be routing the bottom of the cp out
xoopx:
this was the cheap and dirty solution i came up with.
yes, its stuck underneath with epoxy.
it hasnt really ruined the joystick. if i want to re-use it properly its not a big deal to get all that crap off again.
summary. i think it depends on the size of your hands
danny_galaga:
i think id end up snapping that off!
Navigation
[0] Message Index
[*] Previous page
Go to full version