Main > Main Forum
Coin Door Problem
dmsuchy:
I was having a similar issue, what I did was have the wrong tabs hooked up "the open/closed" terminals could be diffrent than your push buttonslike mine.
mikeyv23:
So which ones did you end up using? I was thinking about that too, but did not know if there was a obvious way to check. I will try switching them and hook it up to the IPAC.
SirPeale:
--- Quote from: mikeyv23 on June 07, 2004, 08:39:12 pm ---I can't try a working one without cutting it and putting a bigger connector tab thing on it. The switches on the coin doors have bigger tabs than the ones on the buttons and joysticks.
I tried the multimeter with both wires on and wires off and still got the same reading.
--- End quote ---
You can just hold the wires on with your fingers; you're just testing after all. Also, what dmsuchy stated may be true; try switching the data wires from one to the other.
mikeyv23:
dmsuchy is the WINNER!!!!!!!!!! It was the #%&*@ tabs!! Thank you everybody for putting up with me and all this stuff.
I have one last question though. I now have 2 extra buttons (used to be for the coins), if I hook them up to the SW7 and SW8 spots on the IPAC what can I use them for? Could one of these be my shift key or something?
Thanks again!!!!
;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D
mikeyv23:
This is just not fair. So the coin switches work. But now I hooked the extra two buttons into 1SW7 and 2SW7 and they are not being recognized. The rest of the buttons and switches work, just not these two. They worked when they were coin buttons but now they don't. Any ideas?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version