Main > Main Forum
what kind of dremel bit for t-molding
M3talhead:
Well, that's definitely a vagina.....
Barry Barcrest:
--- Quote from: Franco B on November 12, 2008, 04:17:24 am ---Back on subject.... If I was you I would buy a router and the propper slotting bit. It will cost you slightly more $$$ but routers really are a versatile tool. I only bought a cheap one but its paid for itself 1000 times over.
--- End quote ---
LOL This original thred is from 2002....
Franco B:
Ha! I didnt even notice when the date of the previous post. What a random post to dig up to pr0n :spam: ???
Anyway, everyone buy a router! :)
EvilTwin:
Hey, I am slowly planning my first cabinet, which I will start building in a couple months.
I'm slowly trying to gather the tools I'll need to do it; will this router do the job?
http://www.homedepot.ca/webapp/wcs/stores/servlet/CatalogSearchResultView?D=943983&Ntt=943983&catalogId=&langId=-15&storeId=10051&Dx=mode+matchallpartial&Ntx=mode+matchall&recN=0&N=0&Ntk=P_PartNumber
Or should I be looking at a 'plunge' router? I plan on putting a trackball in the control panel, if that matters.
Then I guess I'll need a 1/16" slot cutting bit?
danny_galaga:
--- Quote from: M3talhead on November 12, 2008, 07:49:20 am ---Well, that's definitely a vagina.....
--- End quote ---
did you click the link to make sure ;D
Navigation
[0] Message Index
[*] Previous page
Go to full version