Main > Main Forum

How do i do this?

<< < (2/2)

Goz:
 What mor help do you need?

Krick hit the nail on the head.  You will need to wait until you have the cab, the control panel, and PCB all at the same place.

Do you know if the monitor is compatible? Will the control panel fit?

If it's a JAMMA cab and if the monitor will work (correct resolution), then it is a simple matter of wiring the buttons from the JAMMA harness and the Kick harness (additional buttons outside of JAMMA std).

 The wiring might look a bit messy from the pics, so you may want to put in a new JAMMA harness, etc. But it would likely be personal prefference vs usability.

Other than the CP size and monitor resolution requirements it should be a piece of cake.

-Goz

wboy:
I know for a fact Tekken 1, 2, 3 and Tag are all 15Khz, Low resolution games that run at 512x240 resolution.

3 and Tag allow you to run interlaced, which is still 15Khz Low Res, and runs at 512x480 resolution.

All Tekken releases are definately JAMMA.  The JAMMA harness and Kick harness all look in place.  Should just plug straight in (small picture, for forgive me if I am wrong).  If your JAMMA harness isn't keyed, make sure you put i on the right way not to damage the tekken board.  Pin 1 on harness to Pin 1 on PCB....

From the pic, it only appears you'll have to wire the power supply.

All other wiring looks fine to me.

Tekken tag would not run on this you don't have the tag button (JAMMA button 3).

talem:
i know , thnx man for the help with the monitor. Hopefully i wont have to do any soldering at all. MY cab is Jamma and the guy ust said it would Play Tekken 3. So hopefully hes right :)

talem:
yeah itll work , its standard resolution

Navigation

[0] Message Index

[*] Previous page

Go to full version