Main > Main Forum
Alternative to 5/8" MDF for control panel?
sofakng:
Well, I'm a bit disappointed at the moment... I'm using 3/4" MDF for my entire cabinet, but since I want to use T-Molding and Plexiglass/Lexan for my control panel, I was told I should purchase 5/8" MDF for the control panel.
I've checked a bunch of lumber places (and chain stores), and nobody seems to carry 5/8" MDF.
Can anybody recommend a good alternative?
As mentioned above, I want to use plexiglass or lexan as well as 3/4" T-Molding. Those are really my only requirements.
Doc-:
You can use 1/2" MDF as long as it is well supported.
Doc-
rdagger:
--- Quote from: sofakng on June 01, 2004, 10:19:24 pm ---I've checked a bunch of lumber places (and chain stores), and nobody seems to carry 5/8" MDF.
--- End quote ---
I have bought several 4'x8' 5/8" MDF sheets at Home Depot.
You might also want to consider a high grade plywood, because it's lighter and less toxic when you cut it.
Bumblebounces:
I used 3/4 inch particle board and 1/4 inch lexan for my control panel. I got around the problems most run into by skinning the edges of the control panel with pieces of 3/4 inch MDF that were cut in 1 inch tall strips, standing on end. I then used a 1/2 in round over bit in my router to route that lip to a nice rounded edge and voila! A nicely edged inset lexan overlay for my CPO underlay. Came out great. I'm not posting from a machine when I have access to a pic but I can post one if you want.
Bumble
sofakng:
Doc: If I use 1/2" MDF, would I then buy 1/4" Plexiglass/Lexan? My goal is to have MDF + Plexiglass/Lexan = 3/4" (the exact size of the t-molding). Would 1/4" plexiglass/lexan be too thick? (would it look right?)
RDagger: I've tried my local Home Depot and Lowe's, and both didn't have it. Lowe's didn't have ANY MDF, but Home Depot had 3/4" and 1/2" (if I remember correctly). I'm going to call a bunch more lumber places today.
Bumblebounces: That sounds like that would work nicely, but are you using 3/4" t-molding? If so, how did you get it to fit? If you have any pictures I'd definitely like to see them. Thanks!
Navigation
[0] Message Index
[#] Next page
Go to full version