Main > Main Forum

Homemade plastic injection molding?

<< < (3/7) > >>

Generic Eric:

--- Quote from: Stormy151 on May 18, 2004, 02:41:01 am ---Depends on the plastic/thickness.  Styrene not so much, but ABS would probably work for a gun holster, so would Kydex.

Buttons, probably not.  You could probably make a cover that fit over an existing button though.

--- End quote ---

Right...about the buttons, I was thinking about what Lilwolf was asking about the T2 grenade button

dag2000:
See : /http://www.studiocreations.com/howto/vacuumforming/index.html

depressd:
What about protoplast pellets or sheets for the molding. You can cast your clay molds in this stuff to make a positive mold.  It's very rigid after it sits for a while. I use it for custom halloween fangs. It works really well. There are tons of free info on using this stuff on various halloween sites.

http://www.wfr-aquaplast.com/tmppcc_default.htm

Psychosylph:
A way to make smaller pieces...

http://www.gruntville.com/howtos/customgrills/index.php

darkcape:
Psychosylph. I think that is exactly what I've been looking for. you all are amazing I will be posting picts of the cabinet when finished. thanks to everyone posting. vacuum forming was more versitile then I though maybe a halloween costume in the future. thanks a tone I hope this discussion continues with more ideas.


lookos like i'll be getting Resin from http://www.alumilite.com/ hope it doesn't cost too much I'll tell what I pay and see if i've been ripped off or got a great deal.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version