Main > Main Forum

BYOAC Custom tokens - optical coin mech?

(1/2) > >>

saint:
For those contemplating tokens but concerned about the size of the token vs. their coin mech -- anyone thought about building one of these circuits?

http://www.oscarcontrols.com/coinswitch/

mp2526:
Doesn't this just replace the coin switch?  Wouldn'y you still need the mech unless of course you replaced it with sometype of straight shoot?

Knoxximus:
You keep the coin mech....it's just that coin size doesn't matter anymore.  Hell, ANY coin you put it will register since all your doing is breaking a light beam.

Chris:

--- Quote from: Knoxximus on May 16, 2004, 03:32:30 pm ---You keep the coin mech....it's just that coin size doesn't matter anymore.  Hell, ANY coin you put it will register since all your doing is breaking a light beam.

--- End quote ---
But the coin still needs to make it through the mech.  If the coin ends up in the reject chute it won't break the beam.

mp2526:

--- Quote from: Chris on May 16, 2004, 05:37:47 pm ---
--- Quote from: Knoxximus on May 16, 2004, 03:32:30 pm ---You keep the coin mech....it's just that coin size doesn't matter anymore.  Hell, ANY coin you put it will register since all your doing is breaking a light beam.

--- End quote ---
But the coin still needs to make it through the mech.  If the coin ends up in the reject chute it won't break the beam.

--- End quote ---

Right, which was my point when I asked the question.  The mech adjustment is really the hard part, although I do like the idea of an optical switch.

Navigation

[0] Message Index

[#] Next page

Go to full version