Main > Main Forum
Starting the cabinet all at once. It works! And here's how...
SirPeale:
I don't see why not. That's what I did.
General Zod:
--- Quote from: Peale on September 02, 2004, 07:10:22 pm ---I don't see why not. That's what I did.
--- End quote ---
Whooohooo!! ;D
I just wanted to say a quick word of thanks to you Peale !! Without your help I don't think I could have wired this cabinet the way I truly wanted. Hats off to ya , my friend !!
I've helped a few people with their MAMEcabs, but I was always doing the pc-side of it .... definitely a little different when it comes to doing the entire haul.
I tried making the wire job as neat as possible, or at least in order. I learned you can never have enough clamps & tie-wraps. ;)
Anyhow ... I don't have a website to host any pictures, but I at least wanted to show you this one .
Thank you again for your help.
Michael
SirPeale:
--- Quote ---
--- End quote ---
Looks good! Just about what mine looks like, but yours is nicer. I haven't had the time to get it 'sparkly' yet.
Mameotron:
Well, good job on getting the problem solved! If I need to do any of this, I know right where to go.
Just as an afterthought, I realized recently that the mobo in my cab DOES power on when the power switch is pressed, not when it is released. It is a Dell Optiplex GX100, rescued from the trash at work. This tidbit may come in handy to someone someday.
danny_galaga:
just an update on my set up. no one will probably remember but i used a relay on my system. i had noted that once in a while the system just wouldnt start up and i promised id give an update on whether it became more or less frequent. well it seems to start every time now. i suspect that as the relay 'wears' in (or out) the speed it takes to switch off has decreased (i think, it's been so long since i set it up i cant remember!)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version