Main > Main Forum
BYOAC Tokens!!! Now Accepting Pre-Orders.
allroy1975:
well, the subject says "it's a go!" but I don't really see in the thread where to order, or that any artwork decisions have been finalized.
I got my hopes up......is it "a GO!"?
maybe I'm missing something, but I'll watch the thread and when it is "a GO!" count me in. ;)
Alllroy
Santoro:
--- Quote from: allroy1975 on May 12, 2004, 09:59:53 pm ---well, the subject says "it's a go!" but I don't really see in the thread where to order, or that any artwork decisions have been finalized.
I got my hopes up......is it "a GO!"?
maybe I'm missing something, but I'll watch the thread and when it is "a GO!" count me in. ;)
--- End quote ---
I only meant that, yes, we are going to do this. For a while the thread was deciding if there was demand. Look for ordering info in the next day or so.
allroy1975:
--- Quote from: Santoro on May 12, 2004, 10:29:56 pm ---Look for ordering info in the next day or so.
--- End quote ---
w00t
Allroy
DPsx7:
--- Quote from: mp2526 on May 12, 2004, 09:36:49 pm ---I quarter is ~.955 inches (24.26 mm) in diameter and 1.75 mm thick.
I assume that what is being ordered from tokens direct are the brass tokens, which are 0.984 (25 mm) in diameter and 1.5 mm thick.
They are oh so slightly larger than a quarter. Large enough they won't pass as quarters through most quarter coin mechs, but not so large you couldn't take a quarter coin mech and bend it and adjust it a bit to accept both quarters and tokens with, what I consider, an acceptable amount of rejects.
I weighed a couple of quarters and .984 brass tokens on my gram scale, and they weighed almost identical. However, these are not token direct tokens, but I can't imagine them being that different.
--- End quote ---
Sounds cool to me. All I need to do is widen the acceptor a little then. As long as it'll work the same, meaning it'll still sort the coins (to a point) without being a plain chute. It may sound dumb, but I'd kinda like to keep the noise of a coin dropping through the mech... Thanks for the info.
DeathDealer:
Sounds good, count me in! :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version