Main > Main Forum

tmolding alternative?????

<< < (8/8)

MameMe:
Yea looks like pathdoc may be using something smaller, maybe 1/8"?  Lets see what he says.

pathdoc2:
I'll have to check and see but  I think its 1/4 inch but not set to the full depth.  Does that make sense?  I lower the bit just low enough to round the corners slightly.  I hope this helps.  Some of my machines are well over 2 years old now.  The machine in this pic has been moved twice and all of the corners/edges are intact.  Unfortunately this pic was take before I hand painted the sideart.  

Navigation

[0] Message Index

[*] Previous page

Go to full version