Main > Main Forum
How to remove small scrapes in t-molding? sanding?
Demon-Seed:
Hi
My cabs t-molding has some minor scratches and instead of re doing it all I was wondering if I could sand them out with a light paper like 250? any suggestions?
thanks
JIM
menace:
a 400 grit wet sand followed by a buffing should do it--you could also just try the buffing by itself with some buffing compound.
Demon-Seed:
Hey
Ok bare with me.. ehehe... I can go buy sand paper at the store, no problem. But what is buffing compound? where would I find that? which section of a store? any certain kind I need to get? how is it applied.
thanks
JIM
Silly newbie I am!! ;D
Stingray:
You can get it at an auto parts store. Don't know how well this would work on plastic though.
T-molding is cheap enough. If the scratches bother you that bad it would be quicker and easier to just replace it.
-S
The Man:
--- Quote from: Demon-Seed on April 28, 2004, 11:18:58 am ---Hi
My cabs t-molding has some minor scratches and instead of re doing it all I was wondering if I could sand them out with a light paper like 250? any suggestions?
thanks
JIM
--- End quote ---
You could give Novus a try:
http://www.noscratch.com/novus/
TM
Navigation
[0] Message Index
[#] Next page
Go to full version