Main > Main Forum

Joystick Hole Size

<< < (2/2)

patrickl:
I just measured, but the stick standard only moves less than 20mm or about 3/4". The balltop only 14mm (9/16").

So, if you are planning to take the stick apart you can driller a much smaller hole. Especially if you are hiding those dust covers it will look a lot better when the hole is smaller.

Lance:

--- Quote from: patrickl on April 23, 2004, 11:43:54 am ---I just measured, but the stick standard only moves less than 20mm or about 3/4". The balltop only 14mm (9/16").

So, if you are planning to take the stick apart you can driller a much smaller hole. Especially if you are hiding those dust covers it will look a lot better when the hole is smaller.

--- End quote ---

Also the dust washer on the ball top is much smaller then the regular tstick handle.  If you are using a ball top make sure you drill a smaller hole or else the washer will not cover it all.

Navigation

[0] Message Index

[*] Previous page

Go to full version